Metal Wire Bracelet Weaving Tutorial with 0.3mm Wire

Today’s tutorials use the same weaving method, compiled together for easy comparison and learning.

Finished Product Display:

Materials:

1. 0.3mm diameter round wire, soft type

2. 0.6mm diameter round wire, hard type

3. Lobster clasp components (optional)

Steps:

1. Take a 20cm thin wire and wrap it five times around your finger.

2. Flatten the coils and bind one end together.

3. Separate the five loops.

4. Use a screwdriver or rod approximately 4mm in diameter.

5. Attach the five loops to the tool.

6. Begin weaving the thin wire as shown below; approximately 2 meters required for a bracelet.

7. After completing the first round, pass the wire end under the crossover point of the previous round.

8. Continue weaving cyclically until reaching 6-7cm in length.

9. Thread two short wires through the end half-loop to facilitate stretching.

10. Pull both ends while shaping to form a spindle-shaped flexible chain.

11. Attach clasps or lobster clasps to both ends.

Bracelet Weaving Tutorial with 0.3mm Metal Wire